Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT SEAT ASSEMBLY
71706
2.REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Climate Control Seat System)
3.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
w/o Climate Control Seat System:
Remove the rubber band from the seat cushion spring.
Disconnect the seat heater connector and detach the seat heater wire harness clamp.
Remove the 3 hog rings.
Open the 2 fasteners and then open the seatback cover.
| *A | for Cloth Seat | *B | for Leather Seat |
Remove the nut, detach the 2 hooks and disconnect the seatback cover bracket from the separate type front seatback spring assembly.
Using a screwdriver, detach the 4 claws and remove the 2 headrest supports.
w/ Climate Control Seat System:
Disconnect the seat heater connector and detach the seat heater wire harness clamp.
Detach the 7 hooks.
Remove the 5 hog rings.
Remove the nut, detach the 2 hooks and disconnect the seatback cover bracket from the separate type front seatback spring assembly.
Using a screwdriver, detach the 4 claws and remove the 2 headrest supports.
Remove the seatback cover with pad from the seatback spring.
71074S
4.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
87510N
5.REMOVE FRONT SEATBACK HEATER ASSEMBLY LH
Cut off the 10 tack pins which fasten the front seatback heater assembly LH to the separate type front seatback cover, and then remove the front seatback heater assembly LH from the separate type front seatback cover.
| *1 | Tack Pin |