Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Power Seat) › from 2013.08
RM1440E _58 Vehicle Interior _056161 SEAT _0274104 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  DISASSEMBLY  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 71849 1.REMOVE SEAT ADJUSTER COVER CAP

B239170

a.

Remove the 2 seat adjuster cover caps.


Hide 71706 2.REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Climate Control Seat System)

a.
B357316

Detach the 2 hooks and disconnect the 2 rubber bands.


b.
B360690E02
0.594,0.76 1,0.688 true 2.813,0.76 2.406,0.688 true 2.823,0.677 3.01,0.854 0.188,0.177 10 false *1 0.417,0.677 0.604,0.854 0.188,0.177 10 false *1

Apply protective tape to the locations shown in the illustration.

Text in Illustration
*1 Protective Tape


c.
B360691E03
0.677,1.844 0.5,1.406 0.5,1.406 0.833,1.729 true 2.729,1.76 2.906,1.323 2.906,1.323 2.573,1.656 true 1.979,2.99 1.979,3.948 true 0.323,1.302 0.51,1.458 0.188,0.156 10 false *1 2.854,1.135 3.042,1.292 0.188,0.156 10 false *1 1.896,3.979 2.083,4.135 0.188,0.156 10 false *a

Insert a screwdriver in the clearance between the front seatback board sub-assembly LH and separate type front seatback assembly.

Text in Illustration
*1 Protective Tape
*a Point (A)


d.

Place the screwdriver at point (A) shown in the illustration and move the screwdriver in the direction of the arrow to detach the 2 guides and remove the 2 seatback board clips from the front seatback board sub-assembly LH.

HINT:

Tape the screwdriver tip before use.



e.
B360692

Move the front seatback board sub-assembly LH in the direction of the arrow to detach the 2 guides and remove the front seatback board sub-assembly LH.


Hide 71769A 3.REMOVE FRONT SEATBACK BOARD CLIP (w/ Climate Control Seat System)

a.
B360693

Remove the 2 front seatback board clips from the separate type front seatback spring assembly.


Hide 84921B 4.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

B239530

a.

Using a moulding remover, detach the 2 claws and remove the slide and vertical power seat switch knob.


Hide 84921A 5.REMOVE RECLINING POWER SEAT SWITCH KNOB

B239532

a.

Using a moulding remover, detach the 2 claws and remove the reclining power seat switch knob.


Hide 71812D 6.REMOVE FRONT SEAT CUSHION SHIELD LH

a.

Remove the screw of the front seat No. 1 inner cushion shield LH and detach the guide.

B239534


b.

Using a moulding remover, detach the 3 claws and guide.


c.

Move the front seat cushion shield LH in the direction of the arrow to detach the clip and remove the front seat No. 1 inner cushion shield LH together with the front seat cushion shield LH as a unit.


d.

Detach the clip of the front seat No. 1 inner cushion shield LH.


e.

Disconnect the lifter motor connector.


f.
B239536

Detach the 3 claws and open the wire harness cover.


g.

Detach the 3 wire harness clamps and disconnect the seat wire connector.


Hide 84922C 7.REMOVE FRONT POWER SEAT SWITCH LH

Hide 84920 8.REMOVE LUMBAR SWITCH ASSEMBLY (for Driver Side)

Hide 71868A 9.REMOVE FRONT SEAT NO. 1 INNER CUSHION SHIELD LH

a.
B239540

Detach the 2 claws and remove the front seat No. 1 inner cushion shield LH.


Hide 71862 10.REMOVE FRONT SEAT INNER CUSHION SHIELD LH (for Driver Side)

a.
B239167

Using a moulding remover, detach the 3 claws and remove the front seat inner cushion shield LH.


Hide 71861 11.REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)

B239169

a.

Using a moulding remover, detach the 4 claws and remove the front seat inner cushion shield RH.


Hide 73240 12.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH

Hide 71440S 13.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

a.

w/o Climate Control Seat System:

i.
B239173

Remove the rubber band from the separate type front seat cushion spring assembly.


ii.
B241809

Detach the clamp and disconnect the No. 2 seat wire.


iii.
B241810

w/ Seat Heater System:

Disconnect the seat heater connector and detach the seat heater wire harness clamp.


iv.
B247920

Detach the 2 hooks.


v.
B239174E04
1.573,3.188 1.74,3.188 1.74,3.188 2.49,3.031 true 1.375,3.104 1.552,3.302 0.177,0.198 10 false *1

Detach the claw and disconnect the airbag connector.


vi.

Detach the 3 airbag wire harness clamps.


vii.

Detach the fastening tape to disconnect the airbag wire harness.

Text in Illustration
*1 Fastening Tape


viii.
B239178

Remove the 4 bolts and separate type front seatback assembly.



b.

w/ Climate Control Seat System:

i.
B247919

Detach the clamp and disconnect the No. 2 seat wire.


ii.

Disconnect the seat heater connector and detach the seat heater wire harness clamp.


iii.
B247920

Detach the 2 hooks.


iv.
B357320E02
1.646,2.333 1.865,2.333 true 1.896,2.25 2.083,2.406 0.188,0.156 10 false *1

Detach the claw and disconnect the airbag connector.


v.

Detach the 3 airbag wire harness clamps.


vi.

Detach the fastening tape to disconnect the airbag wire harness.

Text in Illustration
*1 Fastening Tape


vii.
B239178

Remove the 4 bolts and separate type front seatback assembly.



Hide 71149A 14.REMOVE FRONT SEAT LEG COVER LH

B239171

a.

Detach the 2 claws.


b.

Move the front seat leg cover LH in the direction of the arrow to remove it.


Hide 15.REMOVE SEAT CUSHION COVER WITH PAD

a.
B357321

w/ Seat Heater System:

Disconnect the seat heater connector and detach the 3 seat heater wire harness clamps.


b.

Detach each hook to remove the seat cushion cover with pad.

B357322


Hide 71072S 16.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER

a.
B239182

Remove the 15 hog rings and separate type front seat cushion cover from the separate type front seat cushion pad.


Hide 87510L 17.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH (w/ Seat Heater System)

Hide 71876 18.REMOVE RECLINING ADJUSTER INSIDE COVER LH

a.
B357535

Detach the claw and guide, and then remove the reclining adjuster inside cover LH.


Hide 71874A 19.REMOVE FRONT SEAT LOWER CUSHION SHIELD LH (for Driver Side)

a.
B239543

Remove the screw.


b.

Detach the hook and clip, and then remove the front seat lower cushion shield LH.


Hide 71873B 20.REMOVE FRONT SEAT LOWER CUSHION SHIELD RH (for Driver Side)

a.
B247926

Remove the screw.


b.

Detach the hook and clip, and then remove the front seat lower cushion shield RH.


Hide 71537D 21.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR LH

a.
B239188

Remove the screw.


b.

Move the front seat cushion edge protector LH in the direction of the arrow to detach the hook and remove the front seat cushion edge protector LH.


Hide 71537C 22.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR RH

HINT:

Use the same procedure described for the LH side.


Hide 87501B 23.REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY LH (w/ Seat Heater System)

Hide 85866A 24.REMOVE SEAT CUSHION CLIMATE CONTROL DUCT LH (w/ Climate Control Seat System)

a.
B357323

Detach the 2 claws.


b.
B357324

Detach the 3 claws to remove the seat cushion climate control duct LH.


Hide 85860B 25.REMOVE SEAT CUSHION CLIMATE CONTROL BLOWER ASSEMBLY LH (w/ Climate Control Seat System)

a.
B357325

Disconnect the connector.


b.

Detach the 4 guides and remove the seat cushion climate control blower assembly LH.


Hide 85868A 26.REMOVE SEAT CUSHION CLIMATE CONTROL BRACKET LH (w/ Climate Control Seat System)

a.
B357326

Remove the 2 screws and seat cushion climate control bracket LH.


Hide 82192 27.REMOVE FRONT SEAT WIRE LH

a.

Disconnect each connector and disengage each clamp to remove the front seat wire LH.


Hide 71876A 28.REMOVE RECLINING ADJUSTER INSIDE COVER LH

B239544

a.

Detach the guide and remove the reclining adjuster inside cover LH.


Hide 71875A 29.REMOVE RECLINING ADJUSTER INSIDE COVER RH

HINT:

Use the same procedure described for the LH side.


Hide 30.REMOVE SEATBACK COVER WITH PAD

a.

w/o Climate Control Seat System:

i.
B239192

Remove the 3 hog rings.


ii.

Open the 2 fasteners and separate type front seatback cover.

B242232E02
0.927,0.042 1.156,0.24 0.229,0.198 10 false *A 4.375,0.042 4.604,0.24 0.229,0.198 10 false *B

Text in Illustration
*A for Cloth Seat *B for Leather Seat


iii.
B247934

Remove the nut, detach the 2 hooks and disconnect the seatback cover bracket from the seatback spring.


iv.
B239198

Using a screwdriver, detach the 4 claws and remove the 2 front seat headrest supports.


v.

Remove the seatback cover with pad from the separate type front seatback spring assembly.



b.

w/ Climate Control Seat System:

i.
B360694

Detach the 7 hooks.


ii.
B247933

Remove the 5 hog rings.


iii.
B247934

Remove the nut, detach the 2 hooks and disconnect the seatback cover bracket from the seatback spring.


iv.
B239198

Using a screwdriver, detach the 4 claws and remove the 2 front seat headrest supports.


v.

Remove the seatback cover with pad from the separate type front seatback spring assembly.



Hide 71074S 31.REMOVE SEPARATE TYPE FRONT SEATBACK COVER

a.
B247935

Disconnect the seatback cover bracket from the separate type front seatback pad.


b.
B239205

Remove the 13 hog rings and separate type front seatback cover.


Hide 87510N 32.REMOVE FRONT SEATBACK HEATER ASSEMBLY LH (w/ Seat Heater System)

Hide 85867A 33.REMOVE SEATBACK CLIMATE CONTROL BLOWER LH (w/ Climate Control Seat System)

a.
B357327

Disconnect the connector.


b.

Remove the 4 screws and seatback climate control blower LH.


Hide 85866C 34.REMOVE SEATBACK CLIMATE CONTROL DUCT LH (w/ Climate Control Seat System)

a.
B357328

Detach the 2 claws to remove the seatback climate control duct LH.


Hide 82168 35.REMOVE NO. 2 SEAT WIRE

a.

Disconnect each connector and disengage each clamp to remove the No. 2 seat wire.