Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
87510L
1.INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY LH
Set the front seat cushion heater assembly LH in place with the name stamp side facing the seat cushion cover.
| *1 | Tack Pin |
| *2 | Name Stamp |
Install the front seat cushion heater assembly LH with new 22 tack pins.
Connect the wire harness to the separate type front seat cushion cover.
71072S
2.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER
Using hog ring pliers, install the separate type front seat cushion cover to the separate type front seat cushion pad with 15 new hog rings.
| *1 | Hog Ring Pliers |
Be careful not to damage the separate type front seatback cover.
Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seatback cover.
3.INSTALL SEAT CUSHION COVER WITH PAD
Attach the 7 hooks to install the seat cushion cover with pad.
Connect the seat heater connector and attach the 3 wire harness clamps.
Attach the 2 hooks.
Attach the fastening tape to connect the airbag wire harness.
Connect the seat heater connector and attach the wire harness clamp.
w/o Climate Control Seat System:
Install the rubber band to the separate type front seat cushion spring assembly.
73240
4.INSTALL FRONT SEAT INNER BELT ASSEMBLY LH
71862
5.INSTALL FRONT SEAT INNER CUSHION SHIELD LH (for Driver Side)
71861
6.INSTALL FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)
71812D
7.INSTALL FRONT SEAT CUSHION SHIELD LH
71706
8.INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Climate Control Seat System)
9.INSTALL FRONT SEAT ASSEMBLY