Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT SEAT ASSEMBLY
71706
2.REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Climate Control Seat System)
71812D
3.REMOVE FRONT SEAT CUSHION SHIELD LH
71862
4.REMOVE FRONT SEAT INNER CUSHION SHIELD LH (for Driver Side)
71861
5.REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)
73240
6.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
7.REMOVE SEAT CUSHION COVER WITH PAD
w/o Climate Control Seat System:
Remove the rubber band from the separate type front seatback spring assembly.
Disconnect the seat heater connector and detach the wire harness clamp.
Detach the fastening tape to disconnect the airbag wire harness.
| *1 | Fastening Tape |
Detach the 2 hooks.
Disconnect the seat heater connector and detach the 3 wire harness clamps.
Detach each hook to remove the seat cushion cover with pad.
71072S
8.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Remove the 15 hog rings and separate type front seat cushion cover from the separate type front seat cushion pad.
87510L
9.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH
Disconnect the wire harness from the separate type front seat cushion cover.
Cut off the 22 tack pins and remove the front seat cushion heater from the front seat cushion cover.
| *1 | Tack Pin |