Home › Vehicle Interior › SEAT › CLIMATE CONTROL SEAT SWITCH › from 2013.08
RM1440E _58 Vehicle Interior _056161 SEAT _0274119 CLIMATE CONTROL SEAT SWITCH A

SEAT  CLIMATE CONTROL SEAT SWITCH  INSTALLATION  


PROCEDURE

Hide 84752 1.INSTALL REFRESHING SEAT SWITCH

a.

Attach the 4 claws to install the refreshing seat switch.


Hide 55406B 2.INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 58804A 4.INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 33504F 5.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 55475A 7.INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55474C 8.INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)