88625Q
1.INSTALL COOLER THERMISTOR (ROOM TEMPERATURE SENSOR)
Attach the 2 claws to install the cooler thermistor.
Connect the connector and hose.
83100
2.INSTALL COMBINATION METER ASSEMBLY
55404D
3.INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
55480D
4.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
55447C
5.INSTALL NO. 2 SWITCH HOLE BASE
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
7.CHECK SRS WARNING LIGHT
Check the SRS warning light (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>CHECK MODE PROCEDURE).