1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55447C
2.REMOVE NO. 2 SWITCH HOLE BASE
55480D
3.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
55404D
4.REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
83100
5.REMOVE COMBINATION METER ASSEMBLY
88625Q
6.REMOVE COOLER THERMISTOR (ROOM TEMPERATURE SENSOR)
Disconnect the connector and hose.
Detach the 2 claws and remove the cooler thermistor.