88645H
1.INSTALL NO. 1 PRESSURE SWITCH
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the No. 1 pressure switch.
ND-OIL 8 or equivalent
Install the O-ring on the No. 1 pressure switch.
Install the No. 1 pressure switch.
Connect the connector.
2.CHARGE REFRIGERANT
3.WARM UP ENGINE
4.CHECK FOR REFRIGERANT GAS LEAK
53111
5.INSTALL RADIATOR GRILLE
Install the radiator grille (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>RADIATOR GRILLE>INSTALLATION).
53292A
6.INSTALL UPPER RADIATOR SUPPORT SEAL