Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR
RM1440E _58 Vehicle Interior _056163 HEATING / AIR CONDITIONING _0274146 COMPRESSOR A

HEATING / AIR CONDITIONING  COMPRESSOR  INSTALLATION  


PROCEDURE

Hide 1.ADJUST COMPRESSOR OIL

a.

When replacing the compressor and magnetic clutch with a new one, gradually discharge the refrigerant gas from the service valve, and drain the following amount of oil from the new compressor and magnetic clutch before installation.

Standard:

(Oil capacity inside the new compressor and magnetic clutch: 120 + 15 cc (4.1 + 0.51 fl.oz.)) - (Remaining oil amount in the removed compressor and magnetic clutch) = (Oil amount to be removed from the new compressor when replacing)


NOTICE:
·

When checking the compressor oil level, follow the A/C system precautions.

·

If a new compressor and magnetic clutch is installed without removing some oil remaining in the pipes of the vehicle, the oil amount will be too large. This prevents heat exchange in the refrigerant cycle and causes refrigerant failure.

·

If the volume of oil remaining in the removed compressor and magnetic clutch is too small, check for oil leakage.

·

Be sure to use ND-OIL 8 or equivalent compressor oil.




Hide 88320 2.INSTALL COOLER COMPRESSOR ASSEMBLY

E195719E01
2.976,1.861 3.094,2.037 0.118,0.177 10 2 2.619,1.882 2.737,2.062 0.118,0.180 10 3 3.267,1.279 3.384,1.459 0.118,0.180 10 4 2.946,1.478 3.067,1.641 0.121,0.163 10 1

a.

Install the cooler compressor and stud bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Install the 3 bolts and nut.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)

HINT:

Tighten the bolts and nut in the order shown in the illustration.



c.

Connect the connector.


Hide 88704 3.CONNECT SUCTION HOSE SUB-ASSEMBLY

a.

Remove the attached vinyl tape from the suction hose.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the cooler compressor.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring to the suction hose.


d.
E199373E02
0.135,1.01 0.26,1.177 0.125,0.167 10 false A 2.667,0.979 2.813,1.188 0.146,0.208 10 true B

Connect the suction hose with the 2 bolts.

Torque:
for bolt A : 7.8 N*m (80 kgf*cm, 69 in.*lbf)
for bolt B : 9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 88703 4.CONNECT DISCHARGE HOSE SUB-ASSEMBLY

a.

Remove the attached vinyl tape from the cooler refrigerant discharge hose.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the cooler compressor.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring to the discharge hose.


d.

Connect the discharge hose to the cooler compressor with the bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 27020 5.INSTALL GENERATOR ASSEMBLY