Home › Power Source / Network › 1GR-FE BATTERY / CHARGING › GENERATOR
RM1440E _57 Power Source / Network _056152 1GR-FE BATTERY / CHARGING _0274050 GENERATOR A

1GR-FE BATTERY / CHARGING  GENERATOR  INSTALLATION  


PROCEDURE

Hide 27020 1.INSTALL GENERATOR ASSEMBLY

a.

Install the generator bracket to the generator with the bolt.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


b.

Install the generator with the 2 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


c.

Install the generator bracket with the bolt.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


d.

Attach the wire harness clamp.


e.

Install the wire harness with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


f.

Connect the generator connector to the generator.


g.

Install the generator wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


h.

Close the terminal cap.


Hide 17168 2.INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

Hide 3.INSTALL WIRING HARNESS CLAMP BRACKET

a.

Install the wiring harness clamp bracket with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


b.

Attach the clamp.


Hide 16604 4.INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY

a.

for Integrated Type:

Install the No. 2 idler pulley with the bolt.

Torque:
54 N*m (551 kgf*cm, 40 ft.*lbf)


b.

for Separate Type:

Install the idler pulley cover plate, No. 2 idler pulley and No. 2 idler pulley cover plate with the bolt.

Torque:
54 N*m (551 kgf*cm, 40 ft.*lbf)


Hide 74431 7.INSTALL BATTERY TRAY

Hide 28800 8.INSTALL BATTERY

Hide 74481A 9.INSTALL BATTERY CLAMP

a.

Install the battery clamp with the 2 nuts.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


Hide 10.CONNECT CABLE TO POSITIVE BATTERY TERMINAL

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).