Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER
RM1440E _58 Vehicle Interior _056163 HEATING / AIR CONDITIONING _0274147 CONDENSER A

HEATING / AIR CONDITIONING  CONDENSER  REMOVAL  


PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

a.

Drain the engine coolant (See page Engine / Hybrid System>1GR-FE COOLING>COOLANT>REPLACEMENT).


Hide 16400 2.REMOVE RADIATOR ASSEMBLY

a.

Remove the radiator assembly (See page Engine / Hybrid System>1GR-FE COOLING>RADIATOR>REMOVAL).


Hide 3.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

Hide 88703 4.DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY

E199356

a.

Remove the bolt and disconnect the discharge hose from the cooler condenser.

NOTICE:
·

When removing the bolt, do not allow any tools to contact the pipe.

·

When removing the bolt, hold a part of the pipe near the connector.




b.

Remove the O-ring from the discharge hose.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



Hide 88716A 5.DISCONNECT COOLER REFRIGERANT LIQUID PIPE A

E353406

a.

Remove the 2 bolts and disconnect the liquid pipe A from the cooler condenser.

NOTICE:
·

When removing the bolts, do not allow any tools to contact the pipe.

·

When removing the bolts, hold a part of the pipe near the connector.




b.

Remove the O-ring from the liquid pipe A.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



Hide 88463 6.DISCONNECT NO. 1 COOLER CONDENSER BRACKET

a.
E199360

Remove the bolt and disconnect the No. 1 cooler condenser bracket.


Hide 88463A 7.DISCONNECT NO. 2 COOLER CONDENSER BRACKET

a.
E353410

Remove the bolt and disconnect the No. 2 cooler condenser bracket.


Hide 88460 8.REMOVE COOLER CONDENSER ASSEMBLY

a.
E199363

Remove the 3 bolts and the cooler condenser as shown in the illustration.


Hide 88474 9.REMOVE COOLER DRYER

a.
I030086

Using a 14 mm socket hexagon wrench, remove the cap from the modulator.


b.
I032475

Remove the O-ring from the cap.


c.
E050386

Using pliers, remove the cooler dryer.