53292A
1.REMOVE UPPER RADIATOR SUPPORT SEAL
52129B
2.REMOVE FRONT BUMPER COVER LOWER
51405A
3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
4.DRAIN ENGINE COOLANT
11259
5.REMOVE V-BANK COVER
52119A
6.REMOVE FRONT BUMPER COVER
Remove the front bumper cover (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER>REMOVAL).
52521
7.REMOVE UPPER FRONT BUMPER RETAINER
Remove the 3 bolts and retainer.
53293C
8.REMOVE RADIATOR SIDE DEFLECTOR RH
Using a clip remover, detach the 3 claws and remove the clip. Then move the side deflector so that the radiator can be removed in the step below.
53294C
9.REMOVE RADIATOR SIDE DEFLECTOR LH
Using a clip remover, detach the 3 claws and remove the clip. Then move the side deflector so that the radiator can be removed in the step below.
16571C
10.REMOVE NO. 1 RADIATOR HOSE
16572D
11.REMOVE NO. 2 RADIATOR HOSE
Disconnect the radiator hose from the water inlet.
Detach the clamp and remove the radiator hose.
16470
12.REMOVE RADIATOR RESERVOIR
Disconnect the reservoir hose from the upper side of the radiator tank.
Remove the 3 bolts and radiator reservoir.
32907C
13.DISCONNECT OIL COOLER TUBE
Detach the claw to open the flexible hose clamp, and then remove the 2 bolts to disconnect the oil cooler tube from the fan shroud.
16711
14.REMOVE FAN SHROUD
Loosen the 4 nuts holding the fluid coupling fan.
Remove the fan and generator V-belt (See page Engine / Hybrid System>1GR-FE ENGINE MECHANICAL>DRIVE BELT>REMOVAL).
Remove the 2 bolts holding the fan shroud.
Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.
Be careful not to damage the radiator core.
Remove the fan pulley from the water pump.
16400
15.REMOVE RADIATOR ASSEMBLY
Disconnect the 2 oil cooler hoses.
Remove the 4 bolts and radiator.
16561
16.REMOVE NO. 1 RADIATOR TO SUPPORT SEAL
Remove the seal from the radiator assembly.
16562
17.REMOVE NO. 2 RADIATOR TO SUPPORT SEAL
Remove the seal from the radiator assembly.