A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
88650N
1.INSTALL AIR CONDITIONER AMPLIFIER ASSEMBLY
Attach the 2 claws to install the air conditioner amplifier assembly.
82877
2.INSTALL ECU INTEGRATION BOX RH
Install the ECU integration box RH with the 2 nuts and bolt.
Attach the clamp and connect the connectors.
87201B
3.INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY
55303B
4.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
55443A
5.INSTALL INSTRUMENT PANEL BOX DOOR COVER
55312
6.INSTALL LOWER INSTRUMENT PANEL
55607
7.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55475A
8.INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
Attach the 3 clips and 2 guides to install the No. 2 instrument panel under cover.
62111C
9.INSTALL COWL SIDE TRIM BOARD RH
Attach the clip and claw to install the cowl side trim board.
Install the clip.
67910
10.INSTALL DOOR SCUFF PLATE ASSEMBLY RH
Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate.
11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).