Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM1440E _59 Vehicle Exterior _056166 WINDOW / GLASS _0274161 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Key-off Operation Function Operates even if Operating Conditions are not Satisfied  


DESCRIPTION

·

When the front doors are closed, each power window regulator motor can control its power window operation for approximately 43 seconds after the ignition switch is turned from ON to off by receiving operation permission signals from the main body ECU (instrument panel junction block). However, when approximately 43 seconds have elapsed, or a front side door is opened within approximately 43 seconds of the ignition switch being turned off, all the power window regulator motors disable manual operation.


·

During the auto function operation, when 43 seconds have elapsed and key-off operation is prohibited, the window operation operation stops immediately.


PROCEDURE

1.CHECK LIN COMMUNICATION SYSTEM
a.

Check for LIN communication system DTCs related to the power window control system (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).

OK:

LIN communication system DTCs are not output.




OK

2.CHECK POWER WINDOW OPERATION FUNCTION AFTER IGNITION SWITCH OFF

NG

2.CHECK POWER WINDOW OPERATION FUNCTION AFTER IGNITION SWITCH OFF
a.

Check the power window operation function after the ignition switch is turned off (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).

Result
Result Proceed to
Front side door is opened within 43 sec. but power windows can still operate A
43 sec. pass and power windows can still operate B



A

3.READ VALUE USING INTELLIGENT TESTER (FRONT DOOR COURTESY LIGHT SWITCH)

B

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

3.READ VALUE USING INTELLIGENT TESTER (FRONT DOOR COURTESY LIGHT SWITCH)
a.

Use the Data List to check if the main body ECU (multiplex network body ECU) is functioning properly (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
FL Door Courtesy SW Front door courtesy light switch LH signal / ON or OFF ON: Front door LH closed
OFF: Front door LH open
-
FR Door Courtesy SW Front door courtesy light switch RH signal / ON or OFF ON: Front door RH closed
OFF: Front door RH open
-

OK:

On tester screen, each item changes between ON and OFF according to above chart.




OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

4.CHECK FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
4.CHECK FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
a.

Open a front door and check that the map light illuminates (See page Vehicle Interior>LIGHTING (INT)>FRONT DOOR COURTESY SWITCH>REMOVAL).

OK:

Map light illuminates.




OK

5.CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY

NG

REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY

5.CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY
a.

Temporarily replace the driver side junction block with a new or normally functioning one.


b.

Check that the key-off operation function operates normally.



OK

END (DRIVER SIDE JUNCTION BLOCK ASSEMBLY IS DEFECTIVE)

NG

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)