If any door glass or a power window regulator motor assembly does not operate smoothly, the catch protection function may be triggered automatically, resulting in the auto down operation being unable to fully open the power window.
When a power window regulator motor is reinstalled or replaced, the power window control system must be initialized.
This symptom may occur for any of the windows.
Since the power window control system has functions that use LIN communication, first confirm that there is no malfunction in the communication system by inspecting the LIN communication functions in accordance with the "How to Proceed with Troubleshooting" procedures (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING). Then, conduct the following inspection procedure.
Initialize the power window regulator motor (applicable location) (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
NEXT
Check that all door power windows move when the auto up/down function of the multiplex network master switch assembly and power window regulator switch assembly is operated (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).
Auto up/down function is normal (applicable location).
OK
NG
Remove the power window regulator motor.
Install the window glass to the door glass run.
Check if the power window regulator operates smoothly.
Check that the window glass slides smoothly when sliding it up by hand.
Window glass slides smoothly.
Perform initialization again (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
Make sure that the following conditions are met:
The window glass fits with the glass run without improper contact or deformation.
Foreign objects are not caught in the glass run.
OK
NG