Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Rear Door)
RM1440E _59 Vehicle Exterior _056166 WINDOW / GLASS _0274166 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  INSTALLATION  


PROCEDURE

Hide 85720G 1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

NOTICE:

The regulator arm must be below the intermediate position when installing the rear power window regulator motor assembly.


a.
U149775E01
2.157,1.611 2.291,1.773 0.133,0.162 10 1 1.731,0.446 1.912,0.634 0.181,0.188 10 2 1.021,1.106 1.212,1.284 0.191,0.179 10 3

Using a T25 "TORX" socket wrench, install the power window regulator motor with the 3 screws.

HINT:
·

Tighten the screws in the order shown in the illustration.

·

A new power window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are installed.



Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 69804 2.INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

Hide 68104 3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 68124C 4.INSTALL REAR DOOR QUARTER WINDOW GLASS LH

Hide 67408F 5.INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY LH

Hide 68152C 6.INSTALL REAR DOOR GLASS RUN LH

Hide 67842E 7.INSTALL REAR DOOR SERVICE HOLE COVER LH

Hide 68174A 9.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

Hide 67604 10.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 69278C 11.INSTALL REAR DOOR INSIDE HANDLE BEZEL LH

Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 13.INITIALIZE POWER WINDOW CONTROL SYSTEM

a.

Initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).