Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY › 2009.08–2013.08
RM1440E _59 Vehicle Exterior _056168 DOOR / HATCH _0274177 HOOD LOCK CONTROL CABLE ASSEMBLY A

DOOR / HATCH  HOOD LOCK CONTROL CABLE ASSEMBLY  REMOVAL  


PROCEDURE

Hide 53115B 3.REMOVE RADIATOR GRILLE BRACKET

Hide 86520 4.REMOVE LOW PITCHED HORN ASSEMBLY

Hide 86510 5.REMOVE HIGH PITCHED HORN ASSEMBLY

Hide 53629 6.REMOVE HOOD LOCK CONTROL CABLE COVER

a.
B237113

Remove the 2 screws.


b.

Detach the claw and remove the hood lock control cable cover.


Hide 53510 7.REMOVE HOOD LOCK ASSEMBLY

a.
B237114

Remove the 3 bolts.


b.
B237115

Detach the clamp.


c.

w/ Engine Hood Courtesy Switch:

Disconnect the connector.


d.

w/o Engine Hood Courtesy Switch:

Disconnect the connector cap.


e.

Disconnect the hood lock control cable and remove the hood lock assembly.


Hide 67920 8.REMOVE DOOR SCUFF PLATE ASSEMBLY LH

Hide 53601 10.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.
B237118

Detach the clamp.


b.
B237117

Detach the 3 claws.


c.

Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.


Hide 53630 11.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY

a.

Using a screwdriver, disconnect the clamps shown in the illustration.

U180712E02
0.781,0.5 0.99,0.5 false 1.177,0.5 1.115,0.5 1.115,0.5 1.052,0.781 true 2.063,0.896 2.063,0.76 2.063,0.76 2.177,0.667 false 2.688,0.458 2.646,0.458 2.646,0.458 2.552,0.656 false 1.354,2.146 1.51,2.146 1.51,2.146 1.573,2.365 true 5.844,0.708 6.042,0.708 6.042,0.708 6.083,0.948 false 5.625,1.188 5.917,1.188 false 6.094,2.135 6.302,2.135 6.302,2.135 6.354,2.323 false 6.104,2.708 6.271,2.708 false 1.948,1.365 1.948,1.219 1.948,1.219 1.604,1.104 false 1.927,1.219 2.271,1.073 false 2,0.917 2.167,1.083 0.167,0.167 10 false *2 1.854,1.396 2.021,1.563 0.167,0.167 10 false *4 2.74,0.375 2.906,0.542 0.167,0.167 10 false *1 1.24,0.417 1.406,0.583 0.167,0.167 10 false *2 0.625,0.417 0.792,0.583 0.167,0.167 10 false *1 1.198,2.073 1.365,2.24 0.167,0.167 10 false *1 1.729,0.26 1.958,0.469 0.229,0.208 10 false *a 5.938,2.063 6.104,2.229 0.167,0.167 10 false *1 5.677,0.625 5.844,0.792 0.167,0.167 10 false *1 5.458,1.115 5.625,1.281 0.167,0.167 10 false *3 5.938,2.625 6.104,2.792 0.167,0.167 10 false *3

Text in Illustration
*1 Hood Lock Control Cable *2 Stopper
*3 Wire Harness *4 Grommet
*a Engine Room Side - -

HINT:

Tape the screwdriver tip before use.



b.

Pull the hood lock control cable assembly from the engine compartment to remove it.