Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR(for Front Side) › 2009.08–2013.08
RM1440E _59 Vehicle Exterior _056170 WIPER / WASHER _0274195 WASHER MOTOR(for Front Side) A

WIPER / WASHER  WASHER MOTOR(for Front Side)  INSTALLATION  


PROCEDURE

Hide 85310 1.INSTALL WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.

Install the windshield washer motor and pump to the packing of the washer jar.


Hide 85330 2.INSTALL WASHER JAR

a.
E198972E02
0.708,2.396 1,2.635 0.292,0.24 10 true (1) 1.969,2.344 2.26,2.583 0.292,0.24 10 false (2) 2.802,0.688 3.052,0.927 0.25,0.24 10 true (3)

Attach the guide to install the washer jar, and then install the 3 screws.

HINT:

Tighten the screws in the order shown in the illustration.


Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


Hide 85301 3.INSTALL WASHER INLET SUB-ASSEMBLY

a.

Install the clip to the washer inlet sub-assembly.


Hide 4. FILL WASHER FLUID

a.

Connect the washer hose to the hose of the windshield washer motor and pump assembly and fill the washer jar with washer fluid.


Hide 53875A 5.INSTALL FRONT FENDER LINER RH

Hide 52119A 6.INSTALL FRONT BUMPER COVER

a.

except X-Runner:

Install the front bumper cover (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER>INSTALLATION).


b.

for X-Runner:

Install the front bumper cover (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER(for X-Runner)>INSTALLATION).


Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 8.ADJUST FOG LIGHT AIMING

a.

Adjust the fog light aiming (See page Vehicle Exterior>LIGHTING (EXT)>FOG LIGHT ASSEMBLY>ADJUSTMENT).