Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR(for Front Side) › from 2013.08
RM1440E _59 Vehicle Exterior _056170 WIPER / WASHER _0274195 WASHER MOTOR(for Front Side) A

WIPER / WASHER  WASHER MOTOR(for Front Side)  INSTALLATION  


PROCEDURE

Hide 85310 1.INSTALL WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.

Install the windshield washer motor and pump assembly to the packing of the washer jar.


Hide 85330 2.INSTALL WASHER JAR

a.
E198972E02
0.708,2.396 1,2.635 0.292,0.24 10 true (1) 1.969,2.344 2.26,2.583 0.292,0.24 10 false (2) 2.802,0.688 3.052,0.927 0.25,0.24 10 true (3)

Attach the guide to install the washer jar, and then install the 3 screws.

HINT:

Tighten the screws in the order shown in the illustration.


Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


Hide 85301 3.INSTALL WASHER INLET SUB-ASSEMBLY

a.

Attach the clip to the washer inlet sub-assembly.


Hide 4.FILL WINDSHIELD WASHER FLUID

a.

Connect the washer hose to the hose of the windshield washer motor and pump assembly and fill the washer jar with windshield washer fluid.


Hide 53875A 5.INSTALL FRONT FENDER LINER RH

Hide 52119A 6.INSTALL FRONT BUMPER COVER (w/ TOYOTA Parking Assist-sensor System)

Hide 52119A 7.INSTALL FRONT BUMPER COVER (w/o TOYOTA Parking Assist-sensor System)

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).