Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER(w/ TOYOTA Parking Assist-sensor System) › from 2013.08
RM1440E _59 Vehicle Exterior _056173 EXTERIOR PANELS / TRIM _0274240 FRONT BUMPER(w/ TOYOTA Parking Assist-sensor System) A

EXTERIOR PANELS / TRIM  FRONT BUMPER(w/ TOYOTA Parking Assist-sensor System)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 52103 1.INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY LH

Hide 52102 2.INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 52116A 3.INSTALL FRONT BUMPER SIDE SUPPORT LH

Hide 52115A 4.INSTALL FRONT BUMPER SIDE SUPPORT RH

HINT:

Use the same procedure as for the LH side.


Hide 52026B 5.INSTALL NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY LH

Hide 52025B 6.INSTALL NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 52021 7.INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY

a.

Install the front bumper reinforcement sub-assembly with the 6 nuts and screw.

Torque:
Nut : 30 N*m (306 kgf*cm, 22 ft.*lbf)


Hide 52611 8.INSTALL FRONT BUMPER ENERGY ABSORBER

Hide 53294C 9.INSTALL RADIATOR SIDE DEFLECTOR LH

Hide 53293C 10.INSTALL RADIATOR SIDE DEFLECTOR RH

Hide 52822 11.INSTALL AIR INTAKE DUCT LH

a.

Install the air intake duct LH with the 2 screws.


b.

Install the clip and bolt.


Hide 52821 12.INSTALL AIR INTAKE DUCT RH

HINT:

Use the same procedure as for the LH side.


Hide 52129B 13.INSTALL FRONT BUMPER LOWER COVER

a.

Install the front lower bumper cover with the 5 bolts and clip.


Hide 53298 14.INSTALL COOL AIR INTAKE DUCT (for 4WD)

a.

Install the cool air intake duct with the 4 clips.


Hide 52521 15.INSTALL UPPER CENTER FRONT BUMPER RETAINER

Hide 52119A 16.INSTALL FRONT BUMPER COVER

a.

Connect the 3 connectors.


b.

Attach the 14 claws to install the front bumper cover with radiator grille.


c.

Install the 3 bolts, 10 screws and 6 clips.