CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY, MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
Remove the main body ECU (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| A-29 (ACC) - Body ground | - | ACC power supply | Ignition switch ACC | 11 to 14 V |
| A-30 (BECU) - Body ground | - | Battery power supply | Always | 11 to 14 V |
| A-32 (IG) - Body ground | - | Ignition power supply | Ignition switch ON | 11 to 14 V |
| A-11 (GND1) - Body ground | - | Ground | Always | Below 1 Ω |
| F10-3 (GND2) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
If the result is not as specified, there may be a malfunction on the wire harness side.
Install the main body ECU (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>INSTALLATION).
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F9-3 (HAZ) - 2B-4 (GND1) | W - W-B | Hazard warning signal light signal input | Hazard warning signal switch on | Below 1 V |
| Hazard warning signal switch off | 11 to 14 V | |||
| F9-5 (HU) - 2B-4 (GND1) | LG - W-B | Headlight dimmer switch high signal input | Headlight dimmer switch in head and high | Below 1 V |
| Headlight dimmer switch in head and low | 11 to 14 V | |||
| F9-8 (HF) - 2B-4 (GND1) | V - W-B | Headlight dimmer switch high flash signal input | Headlight dimmer switch in high flash position | Below 1 V |
| Headlight dimmer switch not in high flash position | 11 to 14 V | |||
| F9-20 (CLTB) - 2B-4 (GND1)* | P - W-B | Automatic light control sensor power supply output | Ignition switch off | Below 1 V |
| Ignition switch ON and headlight dimmer switch in AUTO position | 11 to 14 V | |||
| F9-21 (CLTS) - 2B-4 (GND1)* | R - W-B | Automatic light control sensor signal input | Ignition switch off | Below 1 V |
| Automatic light control system operates | Pulse generation
(See waveform 1) |
|||
| F9-27 (FFOG) - 2B-4 (GND1) | L - W-B | Front fog light switch input | Headlight dimmer switch in tail or head and front fog light switch on | Below 1 V |
| Front fog light switch off | 11 to 14 V | |||
| F9-28 (A) - 2B-4 (GND1)* | W - W-B | Headlight dimmer switch AUTO signal input | Headlight dimmer switch in AUTO | Below 1 V |
| Headlight dimmer switch not in AUTO | 11 to 14 V | |||
| F9-29 (HEAD) - 2B-4 (GND1) | SB - W-B | Headlight dimmer switch head signal input | Headlight dimmer switch in head | Below 1 V |
| Headlight dimmer switch not in head | 11 to 14 V | |||
| F9-30 (TAIL) - 2B-4 (GND1) | R - W-B | Headlight dimmer switch tail signal input | Headlight dimmer switch in tail or head | Below 1 V |
| Headlight dimmer switch in neither tail nor head | 11 to 14 V | |||
| 2D-7 (TRLY) - 2B-4 (GND1) | G - W-B | Clearance light signal output | Headlight dimmer switch in tail position | 11 to 14 V |
| Headlight dimmer switch off | Below 1 V | |||
| 2D-9 (FFGO) - 2B-4 (GND1) | W - W-B | Front fog light signal output | Headlight dimmer switch in tail or head and front fog light switch on | 11 to 14 V |
| Front fog light switch off | Below 1 V | |||
| 2D-24 (DIM) - 2B-4 (GND1) | P - W-B | H-LP HI relay drive output | Headlight dimmer switch in high or high flash | Below 1 V |
| Headlight dimmer switch not in high or high flash | 11 to 14 V | |||
| 2D-40 (HRLY) - 2B-4 (GND1) | P - W-B | H-LP LO relay drive output | Headlight dimmer switch in head | Below 1 V |
| Headlight dimmer switch not in head | 11 to 14 V | |||
| 2E-1 (TRLY) - 2B-4 (GND1) | B - W-B | Battery power supply | Always | 11 to 14 V |
| 2F-16 (TRLY) - 2B-4 (GND1) | G - W-B | Taillight and license plate light signal output | Headlight dimmer switch in tail position | 11 to 14 V |
| Headlight dimmer switch not in tail position | Below 1 V | |||
| 2F-27 (FLCY) - 2B-4 (GND1) | R - W-B | Front door courtesy light switch LH input | Front door LH open | Below 1 V |
| Front door LH closed | 11 to 14 V |
*: w/ Automatic Light Control System
If the result is not as specified, the main body ECU may have a malfunction.
Waveform 1
| Item | Content |
|---|---|
| Terminal No. (Symbol) | F9-21 (CLTS) - 2B-4 (GND1) |
| Tool setting | 5 V/DIV., 5 ms./DIV. |
| Condition | Ignition switch ON
Headlight dimmer switch AUTO Automatic light control sensor with a hand → Automatic light control sensor covered exposed to ambient light |
If the ambient light becomes brighter, width A becomes narrower.