Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM
RM1440E _59 Vehicle Exterior _056171 LIGHTING (EXT) _0274213 LIGHTING SYSTEM J

LIGHTING (EXT)  LIGHTING SYSTEM  Headlight (HI-BEAM) Circuit  


DESCRIPTION

The main body ECU receives headlight dimmer switch information signals, and illuminates the high beam headlight.

WIRING DIAGRAM

E199761E02
4.987,2.608 5.143,2.764 0.156,0.156 10 A 4.987,2.765 6.720,3.132 1.732,0.367 10 Main Body ECU (Multiplex Network Body ECU) 4.991,0.891 5.202,1.061 0.211,0.170 10 22 5.313,0.986 5.733,1.156 0.420,0.170 10 DIM 2.826,1.582 3.417,1.752 0.591,0.170 10 H-LP HI 3.466,0.897 3.621,1.062 0.156,0.165 10 1 2.666,0.897 2.822,1.062 0.156,0.165 10 2 3.466,1.223 3.621,1.389 0.156,0.165 10 5 2.666,1.223 2.822,1.389 0.156,0.165 10 3 0.587,0.962 1.455,1.164 0.869,0.202 10 from Battery 0.26,1.976 1.878,2.160 1.619,0.184 10 to High Beam Headlights

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (HEADLIGHT DIMMER RELAY)
a.

Using the intelligent tester, perform the Active Test (See page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DATA LIST / ACTIVE TEST).

Main Body
Tester Display Test Part Control Range Diagnostic Note
Head Light Hi Headlight dimmer relay ON/OFF -

OK:

Relay operates (high beam headlights illuminate).




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT HEADLIGHT DIMMER RELAY (H-LP HI)
2.INSPECT HEADLIGHT DIMMER RELAY (H-LP HI)
a.
E108359E05
2.317,0.788 2.747,0.547 false 2.323,1.418 2.237,1.71 false 2.083,1.166 1.928,1.475 false 2.541,1.074 2.782,1.246 false 0.486,0.725 0.614,0.926 0.128,0.201 10 3 0.488,1.258 0.611,1.459 0.123,0.201 10 2 2.777,0.421 2.905,0.622 0.128,0.201 10 3 2.803,1.137 2.926,1.338 0.123,0.201 10 1 2.169,1.699 2.302,1.900 0.134,0.201 10 5 1.819,1.441 1.947,1.642 0.128,0.201 10 2 1.57,1.28 1.698,1.481 0.128,0.201 10 1 1.567,0.705 1.701,0.906 0.134,0.201 10 5

Remove the headlight dimmer relay from the engine room relay block, junction block.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
Battery voltage applied between terminals 1 and 2 Below 1 Ω




OK

3.CHECK HARNESS AND CONNECTOR (BATTERY - HEADLIGHT DIMMER RELAY [H-LP HI])

NG

REPLACE HEADLIGHT DIMMER RELAY

3.CHECK HARNESS AND CONNECTOR (BATTERY - HEADLIGHT DIMMER RELAY [H-LP HI])
a.
E199762E01
0.375,0.153 0.586,0.323 0.211,0.170 10 *a

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
Headlight dimmer relay terminal 2 - Body ground Always 11 to 14 V
Headlight dimmer relay terminal 3 - Body ground


Text in Illustration
*a Front view of wire harness connector
(to Headlight Dimmer Relay)



OK

4.CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER RELAY [H-LP HI] - MAIN BODY ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER RELAY [H-LP HI] - MAIN BODY ECU)
a.

b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Headlight dimmer relay terminal 1 - A-22 (DIM) Always Below 1 Ω
A-22 (DIM) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR