Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When removing the window frame moulding, black out tape and outside stripe, heat the vehicle body, window frame moulding, black out tape and outside stripe using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Window Frame Moulding | 20 to 30°C (68 to 86°F) |
| Black Out Tape | 20 to 30°C (68 to 86°F) |
| Outside Stripe | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body, window frame moulding, black out tape or outside stripe excessively.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
67492A
2.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
69298A
3.REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH
67602
4.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
68172A
5.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH
67832
6.REMOVE FRONT DOOR SERVICE HOLE COVER LH
87940
7.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
68102
8.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
68151E
9.REMOVE FRONT DOOR GLASS RUN LH
75712B
10.REMOVE FRONT DOOR BELT MOULDING LH
67862
11.REMOVE FRONT DOOR WEATHERSTRIP LH
75756C
12.REMOVE FRONT DOOR REAR WINDOW FRAME MOULDING LH
75922M
13.REMOVE NO. 1 BLACK OUT TAPE LH
Pull back an edge of the black out tape and pull it parallel to the vehicle body to remove it.
75986F
14.REMOVE FRONT DOOR OUTSIDE STRIPE LH
Pull back an edge of the front door outside stripe and pull it parallel to the vehicle body to remove it.
75976G
15.REMOVE FRONT DOOR LOWER OUTSIDE STRIPE LH
Pull back an edge of the lower front door outside stripe and pull it parallel to the vehicle body to remove it.