Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When removing the window frame moulding, black out tape and outside stripe, heat the vehicle body, window frame moulding, black out tape and outside stripe using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Window Frame Moulding | 20 to 30°C (68 to 86°F) |
| Black Out Tape | 20 to 30°C (68 to 86°F) |
| Outside Stripe | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body, window frame moulding, black out tape or outside stripe excessively.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
69278C
2.REMOVE REAR DOOR INSIDE HANDLE BEZEL LH
67604
3.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
68174A
4.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH
67842E
5.REMOVE REAR DOOR SERVICE HOLE COVER LH
68152C
6.REMOVE REAR DOOR GLASS RUN LH
67408F
7.REMOVE REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY LH
68124C
8.REMOVE REAR DOOR QUARTER WINDOW GLASS LH
68104
9.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
75722A
10.REMOVE REAR DOOR BELT MOULDING LH
67872
11.REMOVE REAR DOOR WEATHERSTRIP LH
75762A
12.REMOVE REAR DOOR FRONT WINDOW FRAME MOULDING LH
75924C
13.REMOVE NO. 2 BLACK OUT TAPE LH
Pull back an edge of the No. 2 black out tape and pull it parallel to the vehicle body to remove it.
75978H
14.REMOVE REAR DOOR LOWER OUTSIDE STRIPE LH
Pull back an edge of the rear door lower outside stripe and pull it parallel to the vehicle body to remove it.
75988E
15.REMOVE REAR DOOR OUTSIDE STRIPE LH
Pull back an edge of the rear door outside stripe and pull it parallel to the vehicle body to remove it.