Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2009.08–2013.08
RM1440E _56 Audio / Visual / Telematics _056150 AUDIO / VIDEO _0274026 AUDIO AND VISUAL SYSTEM Y

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:

Use these procedures to troubleshoot the audio and visual system.


PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage with the ignition switch off.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.


Result:
Proceed to
NEXT



NEXT

3.BASIC INSPECTION
3.BASIC INSPECTION
a.

Turn the ignition switch to ON.


b.

Check whether or not the radio receiver turns on.

Result:
Result Proceed to
Radio receiver turns on A
Radio receiver does not turn on B




A

4.CHECK FOR DTC

B

6.PROBLEM SYMPTOMS TABLE
4.CHECK FOR DTC
a.

Check for DTCs and note any codes that are output.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR

HINT:
·

If the system cannot enter the diagnostic mode, inspect the AVC-LAN and all the components that connect to the AVC-LAN for short circuits and repair or replace the problem part.

·

Even if the malfunction symptom is not confirmed, check the DTCs. This is because the system stores past DTCs.




b.

Clear the DTCs.


c.

Check for DTCs by simulating the operation indicated by the DTCs.

Result:
Result Proceed to
DTC is output again A
DTC is not output B




A

5.DIAGNOSTIC TROUBLE CODE CHART

B

6.PROBLEM SYMPTOMS TABLE
5.DIAGNOSTIC TROUBLE CODE CHART
a.

Find the output code in the Diagnostic Trouble Code Chart.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART


Result:
Proceed to
NEXT



NEXT

8.ADJUST, REPAIR OR REPLACE
6.PROBLEM SYMPTOMS TABLE
a.

Refer to the Problem Symptoms Table.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B




A

7.OVERALL ANALYSIS AND TROUBLESHOOTING

B

8.ADJUST, REPAIR OR REPLACE
7.OVERALL ANALYSIS AND TROUBLESHOOTING

b.

Inspect the speaker.





c.

Inspect the steering pad switch assembly.

Click hereSteering>STEERING COLUMN>STEERING WHEEL>INSPECTION


Result:
Proceed to
NEXT



NEXT

8.ADJUST, REPAIR OR REPLACE
8.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

9.CONFIRMATION TEST
9.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END