Use these procedures to troubleshoot the power window control system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs and make a note of any codes that are output.
Clear the DTCs.
Recheck for DTCs. Based on the DTCs output in the first step, try to force output of the same DTC by reproducing the symptoms indicated by the DTC.
| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| DTC B2311 is output | B |
| DTC B2312 is output | B |
| DTC B2313 is output | B |
| LIN communication system DTCs are output | C |
| CAN communication system DTCs are output | D |
A
B
C
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
D
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Refer to Problem Symptoms Table.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault not listed in problem symptoms table | A |
| Fault listed in problem symptoms table | B |
A
B
Operation Check.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK
Terminals of ECU.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>TERMINALS OF ECU
Data List / Active Test.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DATA LIST / ACTIVE TEST
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| Door window regulator replaced or removed/installed | A |
| Door window regulator not replaced or removed/installed | B |
A
B
If a power window regulator switch LED is blinking, initialize the power window regulator.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT