Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD SYSTEM

AUTOMATIC RUNNING BOARD SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use these procedures to troubleshoot the automatic running board system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK FOR DTC
    1. Check for DTCs and make a note of any codes that are output.
      Result 
      Result
      Proceed to
      No DTCs are output
      A
      DTC is output
      B



    B.
    GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    4.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).
      Result 
      Result
      Proceed to
      Fault not listed in problem symptoms table
      A
      Fault listed in problem symptoms table
      B



    B.
    GO TO STEP 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Operation Check (Click here).

    2. Terminals of ECU (Click here).


    NEXT


    6.REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT

        END