Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/ Smart Key System)

DTC    B278A    Short to GND in Immobiliser System Power Source Circuit

for Preparation Click here


DESCRIPTION

This DTC is stored when the engine switch power source supply line is open or shorted.

DTC Code
DTC Detection Condition
Trouble Area
B278A
The engine switch power source supply line is open or shorted.
  1. Harness or connector
  1. Engine switch
  1. Certification ECU

WIRING DIAGRAM


B153714E20


INSPECTION PROCEDURE

NOTICE:
Before replacing the certification ECU, refer to Registration (Click here).

1.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ENGINE SWITCH)
  1. Disconnect the F79 ECU connector.

  1. Disconnect the F71 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F79-28 (VC5) - F71-14 (VC5)
    Always
    Below 1 Ω
    F79-36 (AGND) - F71-8 (AGND)
    F79-28 (VC5) or F71-14 (VC5) - Body ground
    Always
    10 kΩ or higher
    F79-36 (AGND) or F71-8 (AGND) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK CERTIFICATION ECU


    B226518E02
  1. Using an oscilloscope, check the waveform.
    Measurement Condition 
    Item
    Content
    Tester Connection
    F71-14 (VC5) - F71-8 (AGND)
    Tool Setting
    2 V/DIV., 20 ms./DIV.
    Condition
    Engine switch off, key not in cabin and 30 seconds or less after engine switch pushed

    OK:
    Waveform is output normally (refer to illustration).

    Text in Illustration 
    *a
    Component with harness connected
    (Engine Switch)



NG
REPLACE CERTIFICATION ECU (Click here)
OK

REPLACE ENGINE SWITCH (Click here)