Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › SFI SYSTEM

SFI SYSTEM > MIL Circuit

for Preparation Click here


DESCRIPTION

The MIL (Malfunction Indicator Lamp) is used to indicate the detection of vehicle malfunctions by the ECM. When the ignition switch is turned to ON, power is supplied to the MIL circuit and the ECM provides the circuit ground which illuminates the MIL.
The MIL operation can be checked visually; when the ignition switch is first turned to ON, the MIL should be illuminated and should then turn off. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the Techstream.

WIRING DIAGRAM


A227115E01


INSPECTION PROCEDURE

1.CHECK THAT MIL IS ILLUMINATED
  1. Perform troubleshooting in accordance with the table below.
    Result 
    Condition
    Proceed to
    MIL remains ON
    A
    MIL does not illuminate
    B



B
Go to step 5
A


2.CHECK WHETHER MIL TURNS OFF
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON and turn the Techstream on.

  1. Enter the following menus: Powertrain / Engine and ECT / Trouble Code.

  1. Check if any DTCs have been stored. Note down any DTCs.

  1. Clear DTCs (Click here).

  1. Check if the MIL goes off.

    OK:
    MIL goes off.



NG
Go to step 3
OK

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)  

3.CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS)
  1. Disconnect the ECM connector.

  1. Turn the ignition switch to ON.

  1. Check that the MIL is not illuminated.

    OK:
    MIL is not illuminated.

  1. Reconnect the ECM connector.



NG
Go to step 4
OK

REPLACE ECM (Click here)  

4.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)
  1. Disconnect the ECM connector.

  1. Disconnect the combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F51-13 (W) or F14-30 (CHK) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the ECM connector.

  1. Reconnect the combination meter assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPAIR OR REPLACE COMBINATION METER ASSEMBLY (Click here)  

5.CHECK THAT MIL IS ILLUMINATED
  1. Check if the MIL is illuminated when the ignition switch is turned to ON.

    OK:
    MIL is illuminated.



NG
Go to step 6
OK

SYSTEM OK 

6.CHECK THAT ENGINE STARTS
  1. Turn the ignition switch to ON.

  1. Check that the engine starts.
    Result 
    Result
    Proceed to
    Engine starts
    A
    Engine does not start*
    B

    HINT:
    *: The Techstream cannot communicate with the ECM.



B
GO TO VC OUTPUT CIRCUIT (Click here)
A


7.INSPECT COMBINATION METER ASSEMBLY (MIL CIRCUIT)
  1. Refer to the combination meter troubleshooting procedure (Click here).



NG
REPAIR OR REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)