Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the tire pressure warning system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble.

      HINT:
      It is important to collect as much specific information as possible from the customer to allow for a quick repair.


    NEXT


    3.ADJUST TIRE PRESSURE*
    1. Turn the ignition switch off.

    2. Connect the Techstream to the DLC3.

    3. Turn the ignition switch to ON.

    4. Turn the Techstream on.

    5. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

    6. Read the "ID Tire Inflation Pressure" values.

    7. Adjust all tire pressures to the standard values (Click here).

    8. Check the Data List (Click here).

      HINT:
      1. It takes approximately 2 or 3 minutes to display the updated tire pressure data.
      2. If the problem is that the tire pressure was low, wait until all of the tire pressure data is received by the ECU. When the data is received, the tire pressure warning light turns off.

      Result 
      Result
      Proceed to
      Tire pressure warning light remains on
      A
      Tire pressure warning light goes off
      B



    B.
    Go to step 9
    A


    4.CHECK FOR DTC*
    1. Check for DTCs (Click here).
      Result 
      Result
      Proceed to
      DTC is output
      A
      DTC is not output
      B



    B.
    Go to step 6
    A


    5.DTC CHART
    1. Refer to the Diagnostic Trouble Code Chart (Click here).


    NEXT

    Go to step 8


    6.PROBLEM SYMPTOMS TABLE
    1. Refer to the Problem Symptoms Table (Click here).


    NEXT


    7.CIRCUIT INSPECTION*
    1. Refer to the Electronic Circuit Inspection Procedure (Click here).


    NEXT


    8.REPAIR OR REPLACE
    1. Repair or replace parts based on the diagnosis result.


    NEXT


    9.CONFIRMATION TEST*
    1. Check the Data List to confirm that the tire inflation pressure has been received (Click here).


    NEXT

    END