Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SMART KEY SYSTEM (for Entry Function)

SMART KEY SYSTEM (for Entry Function) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the smart key system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the Techstream to check if the CAN communication system is functioning normally.
      Result 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    4.CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*
    1. Use the Techstream to check if the LIN communication system is functioning normally.
      Result 
      Result
      Proceed to
      LIN DTC is not output
      A
      LIN DTC is output
      B



    B.
    GO TO LIN COMMUNICATION SYSTEM (Click here)
    A


    5.CHECK FOR DTC*
    1. Check for DTCs. Based on the DTCs output, try to cause the same steering lock system DTC, engine immobiliser system DTC or smart key system (for Entry Function) DTC to be stored by reproducing the symptoms indicated by the DTC.
      Result 
      Result
      Proceed to
      DTC is not output
      A
      Steering lock system DTC is output
      B
      Engine immobiliser system DTC is output
      C
      Smart key system (for Entry Function) DTC is output
      D



    B.
    GO TO STEERING LOCK SYSTEM (Click here)

    C.
    GO TO ENGINE IMMOBILISER SYSTEM (Click here)

    D.
    GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    6.PROBLEM SYMPTOMS TABLE
    1. Refer to the Problem Symptoms Table (Click here).
      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    Go to step 8
    A


    7.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here).

    2. Data List / Active Test (Click here).

    3. Terminals of ECU (Click here).


    NEXT


    8.REPAIR OR REPLACEMENT

      NEXT


      9.CONFIRMATION TEST

        NEXT

        END