Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SMART KEY SYSTEM (for Entry Function)

SMART KEY SYSTEM (for Entry Function) > Entry Interior Alarm does not Sound

for Preparation Click here


DESCRIPTION

The smart key system uses the combination meter buzzer to perform various vehicle interior warnings. When the conditions of each warning are met, the certification ECU sends a buzzer signal to the combination meter assembly, and the combination meter buzzer sounds.

INSPECTION PROCEDURE

NOTICE:
  1. The smart key system (for Entry Function) uses a multiplex communication system (LIN communication system) and the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (Click here). Troubleshoot the smart key system (for Entry Function) after confirming that the communication systems are functioning properly.
  2. Check that there are no electrical key transmitters in the vehicle.
  3. Before replacing the certification ECU, refer to the engine immobiliser system (w/ Smart Key System) (Click here).

1.CHECK COMBINATION METER ASSEMBLY (OPERATION)
  1. Turn the engine switch on (IG). Place a weight of 20 kg (44.0 lb) on the passenger seat to cause the passenger seat belt warning light to blink.

  1. When driving the vehicle at 15 km/h (9.3 mph) or more, check that the seat belt warning buzzer sounds to inform that the passenger seat belt is not fastened.

    HINT:
    The smart key system sounds the buzzer built into the combination meter for indoor warnings. This buzzer is also used for the seat belt warning system. Therefore, the operation of the combination meter buzzer can be checked by checking if the buzzer sounds to inform that the seat belt is not fastened.

    OK:
    Combination meter buzzer sounds.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPLACE CERTIFICATION ECU (Click here)