Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SMART KEY SYSTEM (for Start Function)

SMART KEY SYSTEM (for Start Function) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the push-button start function.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK

      HINT:
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

      1. The following 5 items are important points in the problem analysis:

        What
        Vehicle model, system name
        When
        Date, time, occurrence frequency
        Where
        Road conditions
        Under what conditions?
        Running conditions, driving conditions, weather conditions
        How did it happen?
        Problem symptoms

    NEXT


    3.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    4.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the Techstream to check if the CAN communication system is functioning normally.
      Result 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
    A


    5.CHECK FOR DTC*
    1. Check for DTCs and note any codes that are output (Click here).

    2. Clear the DTCs (Click here).

    3. Recheck for DTCs.
      Result 
      Result
      Proceed to
      DTC is not output again
      A
      DTC is output again
      B



    B.
    GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    6.INSPECT BASIC OPERATION
    1. Check that the engine can be started by the basic operation.

      1. Push the engine switch when the brake pedal is depressed and the shift lever is in P. Check that the engine starts.

        OK:
        Engine starts.

    2. Check that the engine switch mode can be changed by pushing the engine switch.

      1. Without depressing the brake pedal, push the engine switch repeatedly. Check that the power source mode turns from off to on (ACC) to on (IG) and back to off.

        OK:
        Power source mode changes as described above.

      2. With the brake pedal depressed and the shift lever in P, push the engine switch. Check that the engine starts normally from any power source mode status.

        OK:
        Engine starts normally from any power source mode status.


    NEXT


    7.PROBLEM SYMPTOMS TABLE
    1. Refer to the Problem Symptoms Table (Click here).
      Result 
      Result
      Proceed to
      Fault is not listed in the problem symptoms table
      A
      Fault is listed in the problem symptoms table
      B



    B.
    Go to step 9
    A


    8.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here).

    2. Data List/Active Test (Click here).


    NEXT


    9.REPAIR OR REPLACE

      NEXT


      10.CONFIRMATION TEST

        NEXT

        END