Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Steering Pad Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit sends an operation signal from the steering pad switch assembly to the radio and display receiver assembly.
If there is an open in the circuit, the radio system cannot be operated using the steering pad switch assembly.
If there is a short in the circuit, the resulting condition is the same as if a switch were continuously pressed. Therefore, the radio and display receiver assembly cannot be operated using the steering pad switch assembly, and the radio and display receiver assembly itself cannot function.

WIRING DIAGRAM


E225878E51


INSPECTION PROCEDURE

NOTICE:
The vehicle is equipped with an SRS (Supplemental Restraint System). Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System (Click here).

1.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY
E283447E03
  1. Disconnect the G49 radio and display receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G49-21 (SW1) - G49-23 (SWG)
    No switch pushed
    95 to 105 kΩ
    Up switch pushed
    Below 2.5 Ω
    Down switch pushed
    313 to 345 Ω
    Volume+ switch pushed
    950 to 1050 Ω
    Volume- switch pushed
    2955 to 3265 Ω
    G49-22 (SW2) - G49-23 (SWG)
    No switch pushed
    95 to 105 kΩ
    MODE/HOLD switch pushed
    Below 2.5 Ω
    On hook switch pushed
    313 to 345 Ω
    Off hook switch pushed
    950 to 1050 Ω
    Voice switch pushed
    2955 to 3265 Ω
    G49-24 (SW3) - G49-23 (SWG)
    No switch pushed
    95 to 105 kΩ
    Enter switch pushed
    Below 2.5 Ω
    Back switch pushed
    313 to 345 Ω
    Right switch pushed
    950 to 1050 Ω
    Left switch pushed
    2955 to 3265 Ω

Text in Illustration 
*a
Front view of wire harness connector
(to Radio and Display Receiver Assembly)


NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT STEERING PAD SWITCH ASSEMBLY
  1. Remove the steering pad switch assembly (Click here).

  1. Inspect the steering pad switch assembly (Click here).



NG
REPLACE STEERING PAD SWITCH ASSEMBLY (Click here)
OK


3.INSPECT SPIRAL CABLE SUB-ASSEMBLY
  1. Inspect the spiral cable sub-assembly (Click here).

    NOTICE:
    The spiral cable sub-assembly is an important part of the SRS airbag system. Incorrect removal or installation of the spiral cable sub-assembly may prevent the airbag from deploying. Refer to the pages shown in the brackets.

    HINT:
    1. Removal (Click here)
    2. Installation (Click here)



NG
REPLACE SPIRAL CABLE SUB-ASSEMBLY (Click here)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (RADIO AND DISPLAY RECEIVER - SPIRAL CABLE SUB-ASSEMBLY)