Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION ECU

OCCUPANT CLASSIFICATION ECU > INSTALLATION

for Preparation Click here



1. INSTALL OCCUPANT CLASSIFICATION ECU


    E199504
  1. Attach the claw to install the occupant classification ECU.

    NOTICE:
    If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant classification ECU with a new one.

  1. Connect the 2 connectors.

    NOTICE:
    When installing the occupant classification ECU, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.



2. INSTALL FRONT SEAT ASSEMBLY RH

HINT:
Refer to the procedure from Install Front Seat Assembly (Click here).



3. ZERO POINT CALIBRATION AND SENSITIVITY CHECK
  1. Perform zero point calibration and the sensitivity check (Click here).



4. PERFORM DIAGNOSTIC SYSTEM CHECK
  1. Perform a diagnostic system check (Click here).



5. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).