POWER WINDOW CONTROL SYSTEM > Key-off Operation Function Operates even if Operating Conditions are not Satisfied |
| 1.CHECK LIN COMMUNICATION SYSTEM |
Check for LIN communication system DTCs related to the power window control system (Click here).
|
| ||||
| OK | |
| 2.CHECK POWER WINDOW OPERATION FUNCTION AFTER IGNITION SWITCH OFF |
Check the power window operation function after the ignition switch is turned off (Click here).
| Result | Proceed to |
| Front side door is opened within 43 sec. but power windows can still operate | A |
| 43 sec. pass and power windows can still operate | B |
|
| ||||
| A | |
| 3.READ VALUE USING TECHSTREAM (FRONT DOOR COURTESY LIGHT SWITCH) |
Use the Data List to check if the main body ECU (multiplex network body ECU) is functioning properly (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FL Door Courtesy SW | Front door courtesy light switch LH signal / ON or OFF | ON: Front door LH closed OFF: Front door LH open | - |
| FR Door Courtesy SW | Front door courtesy light switch RH signal / ON or OFF | ON: Front door RH closed OFF: Front door RH open | - |
|
| ||||
| OK | ||
| ||
| 4.CHECK FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY |
Open a front door and check that the map light illuminates (Click here).
|
| ||||
| OK | |
| 5.CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY |
Temporarily replace the driver side junction block with a new or normally functioning one.
Check that the key-off operation function operates normally.
|
| ||||
| OK | ||
| ||