ENGINE > ON-VEHICLE INSPECTION |
| 1. INSPECT IGNITION TIMING |
Warm up the engine.
When using the Techstream:
Connect the Techstream to the DLC3.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / IGN Advance.
Inspect the ignition timing during idling.
Check that the ignition timing advances immediately when the engine speed is increased.
![]() |
When not using the Techstream:
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
| *a | Front view of DLC3 |
Connect the tester probe of a timing light to the wire of the ignition coil connector for the No. 1 cylinder.
![]() |
Inspect the ignition timing during idling.
Remove SST from the DLC3.
Inspect the ignition timing during idling.
Disconnect the timing light from the engine.
| 2. INSPECT ENGINE IDLE SPEED |
Warm up the engine.
When using the Techstream:
Connect the Techstream to the DLC3.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Engine Speed.
Inspect the engine idle speed.
![]() |
When not using the Techstream:
Connect SST to terminal 9 (TAC) of the DLC3.
| *a | Front view of DLC3 |
Race the engine at 2500 rpm for approximately 90 seconds.
Inspect the engine idle speed.
| 3. INSPECT COMPRESSION |
Warm up and stop the engine.
Remove the intake air surge tank (Click here).
Remove the 6 spark plugs (Click here).
Disconnect the 6 fuel injector connectors.
Inspect the cylinder compression pressure.
Insert a compression gauge into the spark plug hole. (Procedure A)
While cranking the engine, measure the compression pressure. (Procedure B)
Repeat procedures A and B for each cylinder.
If the cylinder compression is low, pour a small amount of engine oil into the cylinder through the spark plug hole and repeat procedures A and B for cylinders with low compression.
Connect the 6 injector connectors.
Install the 6 spark plugs (Click here).
Install the intake air surge tank (Click here).
| 4. INSPECT CO/HC |
Start the engine.
Run the engine at 2500 rpm for approximately 180 seconds.
Insert the CO/HC meter testing probe at least 40 cm (1.31 ft) into the tailpipe during idling.
Immediately check the CO/HC concentration during idling and/or at 2500 rpm.
If the CO/HC concentration does not comply with regulations, perform troubleshooting in the order given below.
Check the A/F sensor operation (Click here) and heated oxygen sensor operation (Click here).
See the table below for possible causes, and then inspect and correct the corresponding causes if necessary.
| CO | HC | Symptom | Causes |
| Normal | High | Rough idling |
|
| Low | High | Rough idling (Fluctuating HC reading) |
|
| High | High | Rough idle (Black smoke from exhaust) |
|