Home › Vehicle Exterior › LIGHTING (EXT) › FOG LIGHT ASSEMBLY

FOG LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL FOG LIGHT ASSEMBLY LH
  1. Attach the 2 guides.

  1. Install the fog light assembly LH with the 2 screws.



2. INSTALL FRONT BUMPER SIDE MOULDING SUB-ASSEMBLY LH (w/ Intuitive Parking Assist System)
  1. Attach the 2 claws and guide to install the front bumper side moulding sub-assembly LH.

  1. Install the 2 screws and 3 outside moulding retainers.



3. INSTALL FRONT BUMPER REINFORCEMENT STOPPER RH (w/o Intuitive Parking Assist System, for RH Side)
  1. Attach the guide and 2 claws to install the front bumper reinforcement stopper RH.



4. INSTALL FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
(Click here)


5. INSTALL FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
(Click here)


6. ADJUST FOG LIGHT AIMING
(Click here)