Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL FRONT BUMPER BAR REINFORCEMENT LH (w/o Intuitive Parking Assist System)
  1. Install the front bumper bar reinforcement LH with the 3 screws.



2. INSTALL FRONT BUMPER BAR REINFORCEMENT LH (w/ Intuitive Parking Assist System)
  1. Install the front bumper bar reinforcement LH with the 2 screws.



3. INSTALL HEADLIGHT ASSEMBLY LH
  1. Connect the 4 connectors and install the headlight assembly LH.

  1. Install the 3 screws and bolt.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



4. INSTALL FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
(Click here)


5. INSTALL FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
(Click here)


6. INSTALL FRONT FENDER MAIN SEAL LH
  1. Attach the 4 clips and 2 guides.



7. INSTALL FRONT FENDER MAIN SEAL RH

HINT:
Use the same procedure as for the LH side.



8. INSTALL UPPER RADIATOR SUPPORT SEAL
  1. Install the upper radiator support seal with the 13 clips.



9. ADJUST HEADLIGHT AIMING
(Click here)


10. ADJUST FOG LIGHT AIMING
(Click here)