Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

DTC    B2799    Engine Immobiliser System Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when one of the following occurs: 1) the ECM detects errors in its own communications with the transponder key ECU assembly; 2) the ECM detects errors in the communication lines; or 3) the ECU - ECM communication ID between the transponder key ECU assembly and ECM is different and an engine start is attempted. Before troubleshooting for this DTC, make sure no engine immobiliser DTCs are output. If output, troubleshoot the engine immobiliser DTCs first.

DTC Code
DTC Detection Condition
Trouble Area
B2799
One of the following conditions is met:
  1. An error in communication between the ECM and transponder key ECU assembly.
  2. An error in the communication lines.
  3. The ECU - ECM communication ID is different during communication with the transponder key ECU assembly.
  1. Harness or connector
  2. Transponder key ECU assembly
  3. ECM

WIRING DIAGRAM


B295352E01


INSPECTION PROCEDURE

NOTICE:
When the transponder key ECU assembly and/or ECM is replaced, refer to Registration (Click here).

1.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B2799 is not output.



NG
Go to step 3
OK

USE SIMULATION METHOD TO CHECK (Click here)  

3.REREGISTER ECU - ECM COMMUNICATION ID
  1. Reregister the ECU - ECM communication ID (Click here).


NEXT


4.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


5.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B2799 is not output.



NG
Go to step 6
OK

END 

6.CHECK CONNECTION OF CONNECTOR
  1. Turn the ignition switch off.

  1. Check that the connectors are properly connected to the ECM and transponder key ECU assembly.

    OK:
    Connectors are properly connected.



NG
CONNECT CONNECTOR CORRECTLY
OK


7.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)
  1. Disconnect the F34 ECU connector.

  1. Disconnect the F50 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F34-13 (EFIO) - F50-14 (IMI)
    Always
    Below 1 Ω
    F34-12 (EFII) - F50-20 (IMO)
    F34-13 (EFIO) or F50-14 (IMI) - Body ground
    Always
    10 kΩ or higher
    F34-12 (EFII) or F50-20 (IMO) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


8.REPLACE TRANSPONDER KEY ECU ASSEMBLY
  1. Temporarily replace the transponder key ECU assembly with a new one (Click here).


NEXT


9.REREGISTER ECU - ECM COMMUNICATION ID
  1. Reregister the ECU - ECM communication ID (Click here).


NEXT


10.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


11.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B2799 is not output.



NG
REPLACE ECM (Click here)
OK

END (TRANSPONDER KEY ECU IS DEFECTIVE)