Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System)

WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock control system is operating normally. Check the power door lock control system first before troubleshooting the wireless door lock control system.
  2. Use these procedures to troubleshoot the wireless door lock control system.
  3. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK FOR DTC*
    1. Check for DTCs and note any codes that are output (Click here).

    2. Clear the DTCs (Click here).

    3. Recheck for DTCs.
      Based on the DTCs output above, try to force output of the same LIN communication system DTC or wireless door lock control system DTC by reproducing the symptoms indicated by the DTC.
      Result 
      Result
      Proceed to
      DTC is not output
      A
      LIN communication system DTC is output
      B
      Wireless door lock control system DTC is output
      C



    B.
    Go to LIN COMMUNICATION SYSTEM (Click here)

    C.
    Go to DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    4.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).
      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    Go to step 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here).

    2. Terminals of ECU (Click here).

    3. Data List / Active Test (Click here).


    NEXT


    6.REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT

        END