WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Key System) > Only Wireless Control Function is Inoperative |

| 1.CHECK POWER DOOR LOCK OPERATION |
Check the power door lock operation (Click here).
|
| ||||
| OK | |
| 2.CHECK KEY REMINDER WARNING OPERATION |
Check the key reminder buzzer operation (Click here).
|
| ||||
| OK | |
| 3.CHECK WIRELESS DOOR CONTROL TRANSMITTER |
Check whether the wireless door lock control functions operate normally with another registered transmitter.
|
| ||||
| OK | |
| 4.CHECK TRANSMITTER BATTERY |
Remove the battery from the inoperative wireless door control transmitter (Click here).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Battery positive (+) - Battery negative (-) | Always | 2.5 to 3.2 V |
|
| ||||
| OK | ||
| ||
| 5.CHECK FOR ELECTRICAL NOISE |
Move the transmitter in the vicinity of the door control receiver.
Press and hold either the lock or unlock transmitter switch for 1 second, and check that the doors are locked or unlocked accordingly.
|
| ||||
| OK | ||
| ||
| 6.CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - MAIN BODY ECU) |
Disconnect the O11 receiver connector.
Disconnect the F9 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O11-2 (RDA) - F9-26 (RDA) | Always | Below 1 Ω |
| O11-3 (PRG) - F9-25 (PRG) | ||
| O11-2 (RDA) or F9-26 (RDA) - Body ground | Always | 10 kΩ or higher |
| O11-3 (PRG) or F9-25 (PRG) - Body ground |
|
| ||||
| OK | |
| 7.CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - BATTERY AND BODY GROUND) |
![]() |
Disconnect the O11 receiver connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O11-1 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| O11-5 (+B) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Door Control Receiver) |
|
| ||||
| OK | |
| 8.CHECK DOOR CONTROL RECEIVER (OUTPUT) |
![]() |
Using an oscilloscope, check the waveform.
| Item | Content |
| Tester Connection | O11-2 (RDA) - Body ground |
| Tool Setting | 10 V/DIV., 50 μsec./DIV. |
| Condition | No key in ignition key cylinder, all doors closed and transmitter switch off → on |
|
| ||||
| OK | ||
| ||