Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

DTC    B15FE    XM Tuner Antenna Disconnected

DTC    B15FF    XM Tuner Antenna Short

for Preparation Click here


DESCRIPTION

These DTCs are stored when a malfunction occurs in the satellite radio antenna assembly which is connected to the stereo component tuner assembly.

DTC No.
DTC Detection Condition
Trouble Area
B15FE
The satellite radio antenna assembly is not connected.
  1. No. 2 instrument panel wire
  2. No. 2 antenna cord sub-assembly
  3. No. 3antenna cord sub-assembly
  4. Satellite radio antenna assembly
  5. Stereo component tuner assembly
  6. Navigation receiver assembly
B15FF
A short occurs in the satellite radio antenna assembly.

INSPECTION PROCEDURE

NOTICE:
After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary.

1.CHECK CONNECTION OF SATELLITE RADIO ANTENNA CABLE
  1. Check if the satellite radio antenna cable is securely connected to the stereo component tuner assembly.

    OK:
    Satellite radio antenna cable is securely connected.



NG
SECURELY CONNECT SATELLITE RADIO ANTENNA CABLE
OK


2.REPLACE NO. 3 ANTENNA CORD SUB-ASSEMBLY
  1. Replace the No. 3 antenna cord sub-assembly (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC are output again.

    OK:
    No DTCs are output.



NG
Go to step 3
OK

END 

3.REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY
  1. Replace the No. 2 antenna cord sub-assembly (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC are output again.

    OK:
    No DTCs are output.



NG
Go to step 4
OK

END 

4.REPLACE SATELLITE RADIO ANTENNA ASSEMBLY
  1. Replace the satellite radio antenna assembly (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC are output again.

    OK:
    No DTCs are output.



NG
Go to step 5
OK

END 

5.REPLACE NO. 2 INSTRUMENT PANEL WIRE
  1. Replace the No. 2 instrument panel wire (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC are output again.

    OK:
    No DTCs are output.



NG
Go to step 6
OK

END 

6.REPLACE STEREO COMPONENT TUNER ASSEMBLY
  1. Replace the stereo component tuner assembly (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC are output again.

    OK:
    No DTCs are output.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

END