INTUITIVE PARKING ASSIST SYSTEM > Rear Clearance Sonar Sensor RH Circuit |

| 1.REPLACE NO. 1 ULTRASONIC SENSOR (REAR CORNER SENSOR RH) |
Remove the No. 1 ultrasonic sensor (rear corner sensor RH) (Click here).
Inspect the No. 1 ultrasonic sensor (rear corner sensor RH) (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (REAR CORNER SENSOR RH - CLEARANCE WARNING ECU ASSEMBLY) |
Disconnect the P1 No. 1 ultrasonic sensor (rear corner sensor RH) connector.
Disconnect the F95 clearance warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P1-1 (E) - F95-17 (E1) | Always | Below 1 Ω |
| P1-2 (S) - F95-18 (S1) | Always | Below 1 Ω |
| P1-1 (E) - Body ground | Always | 10 kΩ or higher |
| P1-2 (S) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||