DTC B1630/23 Rear Airbag Sensor RH Circuit Malfunction |
DTC B1635/24 Rear Airbag Sensor LH Circuit Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1630/23 | Either condition is met:
|
|
| B1635/24 | Either condition is met:
|
|


| 1.CHECK FOR DTC |
Turn the ignition switch to ON.
Clear the DTCs stored in memory (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Check for DTCs (Click here).
| Result | Proceed to |
| DTC B1630 and B1635 are not output | A |
| DTC B1635 is output | B |
| DTC B1630 is output | C |
|
| ||||
|
| ||||
| C | |
| 2.CHECK REAR AIRBAG SENSOR RH |
![]() |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Interchange the rear airbag sensor LH with RH and connect the connectors to them.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Clear the DTCs stored in memory (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 90 seconds.
Check for DTCs (Click here).
| Result | Proceed to |
| DTC B1630 and B1635 are not output | A |
| DTC B1635 is output | B |
| DTC B1630 is output | C |
| *1 | Rear Airbag Sensor LH |
| *2 | Center Airbag Sensor |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Return the rear airbag sensor LH and RH to their original positions and connect the connectors to them.
|
| ||||
|
| ||||
| C | ||
| ||
| 3.CHECK REAR AIRBAG SENSOR LH |
![]() |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Interchange the rear airbag sensor LH with RH and connect the connectors to them.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Clear the DTCs stored in memory (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 90 seconds.
Check for DTCs (Click here).
| Result | Proceed to |
| DTC B1630 and B1635 are not output | A |
| DTC B1630 is output | B |
| DTC B1635 is output | C |
| *1 | Rear Airbag Sensor RH |
| *2 | Center Airbag Sensor |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Return the rear airbag sensor LH and RH to their original positions and connect the connectors to them.
|
| ||||
|
| ||||
| C | ||
| ||