Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

DTC    C2173/73    Vehicle Speed or Engine Speed Signal Malfunction

for Preparation Click here


DESCRIPTION

The tire pressure warning ECU receives a vehicle speed signal from the combination meter and an engine speed signal from the ECM. The tire pressure warning ECU uses these signals to store DTCs C2121/21 to C2124/24.

DTC Code
Detection Condition
Trouble Area
C2173/73
Either condition is met for a total of 15 minutes:
(a) No engine speed signal while the vehicle speed is 8 km/h (5 mph) or more.
(b) No vehicle speed signal while the engine speed is a specified value.
  1. Combination meter assembly
  2. ECM
  3. Harness or connector
  4. Tire pressure warning ECU

HINT:
This DTC is stored at the same time DTCs C2121/21 to C2124/24 are stored.


WIRING DIAGRAM


C162299E31


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform registration of the transmitter IDs into the tire pressure warning ECU after the ECU and/or the tire pressure warning valve and transmitter has been replaced (Click here).

1.PERFORM SIGNAL CHECK (VEHICLE SPEED SIGNAL AND ENGINE SPEED SIGNAL)
  1. Enter signal check mode in the Test Mode Procedure (Click here).

  1. Drive the vehicle at 20 km/h (12 mph) or more for 10 seconds to clear DTCs C2191/91 and C2194/94.

  1. Check the test mode DTCs.
    Result 
    Result
    Proceed to
    DTCs C2191/91 and C2194/94 are cleared
    A
    DTC C2191/91 is output
    B
    DTC C2194/94 is output
    C

    HINT:
    DTCs C2181/81 to C2184/84 (Transmitter ID not Received) are output at this time, but they are not related to this check.



B
GO TO DTC C2191/91 (Click here)

C
GO TO DTC C2194/94 (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)