Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM

DTC    B1675/82    Rear Floor Airbag Sensor Malfunction

for Preparation Click here


DESCRIPTION

The rear floor side airbag sensor consists of the diagnostic circuit, rear floor deceleration sensor, etc.
If the center airbag sensor receives signals from the rear floor deceleration sensor, it determines whether the SRS should be activated.
DTC B1675/82 is stored when a malfunction is detected in the rear floor side airbag sensor circuit.

DTC Code
DTC Detection Condition
Trouble Area
B1675/82
Either condition is met:
  1. A rear floor side airbag sensor malfunction.
  2. A center airbag sensor malfunction.
  1. Rear floor side airbag sensor
  2. Center airbag sensor assembly

WIRING DIAGRAM


C216829E01


INSPECTION PROCEDURE

NOTICE:
When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (Click here).

1.CHECK REAR FLOOR SIDE AIRBAG SENSOR


    C171812E03
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Temporarily replace the rear floor side airbag sensor with a new one.

  1. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Clear the DTCs stored in memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Check for DTCs (Click here).

    OK:
    DTC B1675 is not output.

    HINT:
    Codes other than DTC B1675 may be output at this time, but they are not related to this check.

    Text in Illustration 
    *1
    Rear Floor Side Airbag Sensor
    *2
    Center Airbag Sensor



NG
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)
OK

REPLACE REAR FLOOR SIDE AIRBAG SENSOR (Click here)