Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR FLOOR AIRBAG SENSOR

REAR FLOOR AIRBAG SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL REAR FLOOR SIDE AIRBAG SENSOR
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Install the rear floor airbag sensor with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. If the rear floor airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    2. When installing the rear floor airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

  1. Check that the rear floor airbag sensor is not loose.

  1. Connect the connector.



2. INSTALL REAR FLOOR SIDE AIRBAG SENSOR COVER
  1. Attach the clip and claw to install the cover.

  1. Return the floor carpet to its original position.



3. INSTALL REAR DOOR SCUFF PLATE LH
  1. Attach the 3 clips, 6 claws and 2 guides to install the rear door scuff plate LH.



4. INSTALL REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedure as for the LH side.



5. INSTALL QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)
  1. Install the quarter scuff plate LH with the 2 bolts.



6. INSTALL QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)

HINT:
Use the same procedure as for the LH side.



7. INSTALL REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)
  1. Attach the 2 claws to install the rear No. 1 floor step cover.

    HINT:
    Use the same procedure for all the rear No. 1 floor step covers.



8. INSTALL REAR NO. 1 SEAT ASSEMBLY
  1. for 60/40 Split Double-folding Seat Type LH Side

    1. Install the rear No. 1 seat assembly (Click here).

  1. for 60/40 Split Double-folding Seat Type RH Side

    1. Install the rear No. 1 seat assembly (Click here).

  1. for 60/40 Split Slide Walk-in Seat Type LH Side

    1. Install the rear No. 1 seat assembly (Click here).

  1. for 60/40 Split Slide Walk-in Seat Type RH Side

    1. Install the rear No. 1 seat assembly (Click here).



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



10. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).