Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR

STEERING GEAR > INSTALLATION

for Preparation Click here



1. INSTALL RACK AND PINION POWER STEERING GEAR ASSEMBLY
  1. Install the steering gear assembly with the 2 bolts and 2 nuts.

    Torque:
    120 N*m{ 1224 kgf*cm , 89 ft.*lbf }

    NOTICE:
    Hold the nuts and tighten the bolts to install the power steering link assembly.



2. CONNECT PRESSURE FEED TUBE ASSEMBLY
  1. Install the pressure feed tube clamp with the bolt.

    Torque:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }

  1. Connect the pressure feed tube (return tube side) to the steering gear with the clamp.

  1. Using a union nut wrench, connect the pressure feed tube (pressure feed tube side) to the steering gear. Using a union nut wrench, connect the tube to the vane pump.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    HINT:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).



3. CONNECT TIE ROD END SUB-ASSEMBLY LH
  1. Connect the tie rod end to the steering knuckle with the nut.

    Torque:
    91 N*m{ 928 kgf*cm , 67 ft.*lbf }

    NOTICE:
    Tighten the nut up to an additional 60° if the holes for the cotter pin are not aligned.

  1. Install a new cotter pin.



4. CONNECT TIE ROD END SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



5. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT
  1. Connect the No. 2 steering intermediate shaft (Click here).



6. INSTALL ENGINE ASSEMBLY
  1. Install the engine assembly (Click here).



7. ADD POWER STEERING FLUID


8. BLEED AIR FROM POWER STEERING FLUID
  1. Bleed air from the power steering fluid (Click here).



9. CHECK FOR POWER STEERING FLUID LEAK


10. INSTALL FRONT WHEELS


11. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


12. ADJUST FRONT WHEEL ALIGNMENT
  1. Adjust the front wheel alignment (Click here).