Home › General › MAINTENANCE › CHASSIS

CHASSIS > GENERAL MAINTENANCE



1. INSPECT STEERING LINKAGE AND GEAR HOUSING
  1. Check the steering wheel free play.

  1. Check the steering linkage for looseness or damage.

    1. Check that the tie rod ends do not have excessive play.

    2. Check that the dust seals and boots are not damaged.

    3. Check that the boot clamps are not loose.

    4. Check that the steering gear housing is not damaged.

    5. Check that the connectors are properly connected to the steering gear housing.



2. INSPECT BALL JOINT AND DUST COVER
  1. Inspect the ball joints for excessive looseness.

    1. Jack up the front of the vehicle and place wooden blocks with a height of 180 to 200 mm (7.09 to 7.87 in.) under the front tires.

    2. Lower the vehicle until the front coil spring has about half its ordinary load. Place stands under the vehicle for safety.

    3. Check that the front wheels are pointing straight ahead. Use wheel chocks on all 4 wheels.

    4. Using a lever, pry up the end of the lower arm. Check the amount of play.

      Maximum ball joint vertical play:
      0 mm (0 in.)

      If there is any play, replace the ball joint.

  1. Check the dust cover for damage.



3. INSPECT DRIVE SHAFT BOOTS
  1. Check the drive shaft boots for loose clamps, grease leakage, kinks or damage.



4. INSPECT AUTOMATIC TRANSMISSION FLUID
  1. Inspect the automatic transmission fluid.
    Type
    See procedure
    A750E
    Click here
    A750F
    Click here



5. REPLACE AUTOMATIC TRANSMISSION FLUID
  1. Replace the automatic transmission fluid.
    Type
    See procedure
    A750E
    Click here
    A750F
    Click here



6. INSPECT TRANSFER OIL (for 4WD)
  1. Inspect the transfer oil.
    Type
    See procedure
    VF2A
    Click here
    VF2BM
    Click here
    VF4BM
    Click here



7. REPLACE TRANSFER OIL (for 4WD)
  1. Replace the transfer oil.
    Type
    See procedure
    VF2A
    Click here
    VF2BM
    Click here
    VF4BM
    Click here



8. INSPECT FRONT DIFFERENTIAL OIL (for 4WD)
  1. Inspect the front and rear differential oil (Click here).



9. REPLACE FRONT AND REAR DIFFERENTIAL OIL
  1. Replace the front and rear differential oil (Click here).



10. LUBRICATE PROPELLER SHAFT AND TIGHTEN BOLTS
  1. Lubricate the propeller shaft by referring to the lubrication chart. Before pumping in grease, wipe off any mud and dust on the grease fitting.

  1. Grease grade
    Spider
    Lithium base chassis grease NLGI No. 2
    Slide yoke and double Cardan joint
    Molybdenum disulphide lithium base chassis grease NLGI No. 2

  1. Tighten the bolts of the propeller shaft.